|
|
 |
ASI MP 5405 Epoxy Adhesive
|
ASI MP 5405 is a two part unfilled epoxy adhesive designed for ceramics, and most plastics. It cures to a tough semi-rigid material, and is free flowing in viscosity. It gives good resistance to water, salt spray, inorganic acids and bases, and most organic solvents. It was especially formulated to a 1:1 mix ratio for use in either MMD equipment or side-by-side dual cartridges for easy dispensing.
A handling cure is normally achieved at room temperature within 20 - 30 minutes with full cure in 24 hours. An elevated temperature cure schedule can be used to reach final properties quickly.
|
|
Request For Quote & Ordering Information
Catalog
Number |
Description |
UM |
Ship
Note |
Qty |
|
Click Here to View Closeout Specials
S&H - Freeman charges standard published UPS/FedEx shipping rates (unless freight is specified). All orders under $25 are subject to a $5 small order fee. International orders are subject to a $250 minimum order.
SO = Special Order, Minimum Quantities and Extended Lead Times May Apply.
HAZ-G = Hazardous material, cannot ship air, $20 surcharge applied for each package shipped ground
HAZ-A = Hazardous material, cannot ship air, no surcharge for ground shipping
FRT = must be sent by freight carrier due to size, weight, or hazardous classification
T = Thickness L = Length W = Width H = Height Dia = Diameter Rad = Radius
Net Wt. = Net Weight (shipping weight may be more)
|
|
|
|
