Partall Film #10

Partall Film #10 is a water and alcohol based polyvinyl alcohol (PVA) coating comprised of water soluble, film forming materials. It is excellent for releasing epoxies, polyesters, and urethanes.

Recommended application procedure is apply wax, then PVA Mold Release then wax again.

PVA is water soluble, so following the use of this release procedure, wash the resulting mold surface using warm water to remove the residual PVA and dry completely.

Caution: When pouring a part from the completed mold where PVA was used as a release agent, DO NOT use PVA again. Possible sticking of the part may occur.

To properly release from a mold where PVA was used as a part of the release procedure, apply 3 coats of wax release only, wiping the excess between coats.

Partall Film #10 is now offered in a single pint can for those who require only a small amount of material and want to avoid the hazardous shipping charges accrued by ordering a gallon size.

Related Products & Accessories

Catalog Number Description Qty  
054251 Partall #10 Mold Release 1 Pint
054256 Partall #10 Mold Release 1 Gal
054261 Partall #10 Mold Release 5 Gal
054262 Partall #10 Mold Release Clear 5 Gal

Click Here to View Closeout Specials

S&H - Freeman charges standard published UPS/FedEx shipping rates (unless freight is specified). All orders under $25 are subject to a $5 small order fee. International orders are subject to a $250 minimum order.
SO = Special Order, Minimum Quantities and Extended Lead Times May Apply.
HAZ-G = Hazardous material, cannot ship air, $28.50 surcharge applied for each package shipped ground.
HAZ-A = Hazardous material, cannot ship air, no surcharge for ground shipping.
HAZ-T = Toxic material, must be sent by freight carrier.
FRT = must be sent by freight carrier due to size, weight, or hazardous classification.